Create and Run Install Tasks
Installation tasks will install the CAC/PIV embedded software on the devices you specify within each task. You need to create an installation task for the templates you created in Upload Embedded Files to SLNX Configuration Template.
Create and run the SLNX Embedded CAC. After installing this application, wait a few minutes after the install task completes and confirm that the start-up screen appears on at least one of the target MFPs.
-
Click [Configuration] ®[Configuration Tasks].
-
Click
[Add]. -
On the General tab, enter a [Name] for the installation task (SLNX Embedded CAC). Enter a description if preferred.
-
For Type, select [Apply].
-
On the Template tab, enable [Force Reboot after Template Execution] and then click
[Select Target Template]. From the list of available templates on the left, select the template that contains the SLNX Embedded CAC template you created previously and then click Move Right ▶ to place it in the Target Template list. Click [OK] to close the window. -
On the Target Devices/Groups tab, click either [Add Target Device] or [Add Target Group] to identify the MFP’s on which you will install the CAC/PIV embedded application files.
-
Click
[Save] to save the task, and then click 
[Run Immediately] to run the task and install the application on the MFP.
After installing this application, wait a full minute after the install task completes and confirm that the start-up screen appears on at least one of the target MFPs before proceeding.
To remove the CAC/PIV Embedded software from the MFPs, you can create an uninstall template and then register the template to a task to remove the CAC/PIV embedded solution from the MFPs.
