Select the Information to Send to @Remote Center

1. Click [@Remote] → [@Remote Settings].

2. In the list, select the server to be connected to @Remote.

3. On the [Connector Settings] tab, select the [Send IP addresses] check box. The table below describes all options on the Connector Settings tab.

Disabling these items may affect device management on @Remote Center. Contact a RICOH service representative before disabling this item.

Item	Description
Send IP addresses	Specify whether or not to send the IP address to Ricoh.
Send non-RICOH devices information	Specify whether or not to send the information of non- Ricoh devices.
Request number	Enter the request number for connecting to @Remote Center.
RC gate ID	Automatically displays the RC gate ID.
Status	Displays the registration status of the server to @Remote Center.
Test Call button	Attempts to obtain a command from @Remote Center.
[Confirm Communication] button	Attempts to connect to @Remote Center. If the connection attempt fails, detailed information is displayed.
Change encryption length	Select the length of the encryption key. [512 bit] [2048 bit] The default is [512 bit].
@Remote center address	Displays the address of @Remote Center. Click the [Change] button to change the address.

4. Click (Save).